After SysPrep, the installation failed.

[MOoD90s 0]

Good morning.
I noticed some strange behavior after the SySPrep Audit Mode procedure.
I tried both the W11 24H2 ISO and the new 25H2 ISO to run some tests in audit mode, without including any updates or apps.
Then I generalized and shut down the system, and the virtual machine ended the session normally without any SysPrep errors.
When I install the generalized ISO to verify the ISO I created, I get an installation error.

Then I performed a specific test:
I decompressed the ISO 23H2 and replaced the “boot” folder and the “install.wim” file taken from the ISO 24H2/25H2.
In the virtual machine, following the usual procedure in Audit Mode, I performed the generalization without any problems.
When installing the ISO created to verify the procedure, the operating system installs normally without any error messages.
So I cannot understand the causes of the error I was getting previously with the original 24H2 and 25H2 disk structure.

Thanks for the advice.